INSTRUCTION MANUALVCC-4594COLOR CCD CAMERA About this manualBefore installing and using the camera, please read this manualcarefully. Be sure to keep
MOUNTING THE LENSRewiring the lens cable in the lens iris plug1 Prepare the lens cable.Cut the cable at the plug, then remove approx. 8 mm of the cabl
CONNECTIONSBasic connection for monitoring or recordingThe peripheral devices (VCR, monitor, lens, etc.) and cables are sold separately.1 Make the vid
SETTINGSThe illustration shows the factory default settings for the switches in the camera setup section.The camera settings are described on the assu
SETTINGSIris function settingThis should normally be set to the down (AI) position.Use a manual or fixed iris lens and set the lens aperture to thesho
SETTINGSBacklight compensation settingThis camera has two different backlightcompensation functions: Normally backlightcompensation switch 3 (MULT) an
SETTINGSWhite balance adjustmentNormally the switch 5 (WB) is set to the down (ATW: auto whitebalance) position and the white balance is adjusted auto
SETTINGSLens iris adjustmentIf using a DC type auto-iris lens, you will need to set the LEVEL(VR301) volume when shooting in the conditions described
SETTINGSManual color/black and white settingConnect each pin of the CONTROL terminal as indicated below, toset the image to black and white or color a
SPECIFICATIONSCamera:Scanning system : NTSC standard TV system (525 TVlines, 30 frames/sec.)Interlace : PLL 2:1 interlaceImage device : 1/3 inch solid
SANYO INDUSTRIAL VIDEOCOLOR VIDEO CAMERA LIMITED WARRANTYOBLIGATIONSIn order to obtain warranty service, the product must be delivered to and picked u
Depending on the conditions of use, installation and environment,please be sure to make the appropriate settings and adjustments. Ifyou need help with
1AC6P1P2420--L53Z4/US(0401KP-DSP)21605 Plummer Street,Chatsworth, California 91311Printed in JapanL53Z4/US GB 2001, 4, 2
INFORMATION TO USERSafety GuardTHIS SYMBOL INDICATES THAT THERE AREIMPORTANT OPERATING AND MAINTENANCEINSTRUCTIONS IN THE LITERATURE ACCOMPANYINGTHIS
PRECAUTIONSIn case of problemDo not use the camera if smoke or a strange odour comes from theunit, or if it seems not to function correctly. Disconnec
PARTS NAMES1 Power indicator (POWER)Comes on when the power to the camera is on.2 Video output connector (VIDEO OUT: BNC type)Connect this connector t
PARTS NAMES8 Flange-back lock screw9 Lens mount capThe cap is installed to protect the lens mount section.Remove the lens mount cap before installing
CONCERNING AUTO-IRIS LENSESDC type auto-iris lensA lens without amplifier circuit that operates only on a DC power source. In general, this type of le
FLANGE-BACK ADJUSTMENTIf the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out offocus (in pa
MOUNTING THE LENSPlease use a DC type auto-iris lens (sold separately).Checking the lens mountDo not use a lens if length “L” is more than 5 mm. If no
Kommentare zu diesen Handbüchern