Sanyo PLC-EF60A Bedienungshandbuch PDF herunterladen (Seite 30)

Basic Operation

Information

Choose either Input 1, Input 2, Input 3, Input 4, or Input 5 by

pressing the INPUT button on the top control or the INPUT 1,

INPUT 2, INPUT 3, INPUT 4, or INPUT 5 buttons on the remote

control.

Before using these buttons, correct input source should be

selected through menu operation as described on pages 36~37.

Input 1

Input 3

Input 2

INPUT button

Input 5

Input 4

Auto PC Adjustment function is provided to automatically adjust

Fine sync, Total dots, Horizontal, and Vertical picture position to

conform to your computer by just pressing the AUTO PC ADJ. on

the top control or on the remote control.

Information display can be used to confirm the current operating

condition of the projector and the signal being projected through

the projector.

Press the INFORMATION button on the top control or the INFO

button on the remote control to display Information window on the

screen. To hide the Information window, press the

INFORMATION/INFO button again.

Use this menu to check the projector's operating condition when

you face troubles in operation. Refer to the Information menu on

page 59.

✔Note:

• Fine sync, Total dots, and Picture Position of some computers can not be fully

adjusted with this Auto PC Adjustment function. When the image is not provided

properly with this operation, manual adjustments are required. (p.41, 42)

• Auto PC Adjustment function cannot be operated in Digital Signal input on DVI

terminal and 480i, 575i, 480p, 575p, 720p (HDTV), 1035i (HDTV), 1080i/50

(HDTV), or 1080i/60 (HDTV) is selected on System menu (P.39).

Auto PC Adjustment

Input Selection

✔Note:

Input 4 and Input 5 can not be selected when no interface board is inserted into the

respective slots. (p.21)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 81 82

Keine Kommentare

Sanyo PLC-EF60A Bedienungshandbuch Seite 30