Sanyo PLC-XU75 Bedienungshandbuch PDF herunterladen (Seite 14)

To the AC outlet.

(200 - 240 V AC)

InstallationInstallation

This projector uses nominal input voltages of 100-120 V

or 200-240 V AC. This projector automatically selects

the correct input voltage. It is designed to work with

single-phase power systems having a grounded neutral

conductor. To reduce the risk of electrical shock, do not

plug into any other type of power system.

Consult your authorized dealer or service station if you

are not sure of the type of power being supplied.

Connect the projector with all peripheral equipment

before turning the projector on. (See pages 15-17 for

connection.)

Connecting the AC Power Cord

Connect the AC power cord (supplied) to the

projector.

The AC outlet must be near this equipment

and must be easily accessible.

NOTE ON THE POWER CORD

AC power cord must meet requirement of the country where you use the projector.

Confirm the AC plug type with the chart below and proper AC power cord must be used.

If supplied AC power cord does not match your AC outlet, contact your sales dealer.

To power cord

connector on your

projector.

Projector side

AC outlet side

Ground

To the AC outlet.

(120 V AC)

For the U.S.A. and Canada

To the AC outlet.

(200 - 240 V AC)

CAUTION

For safety, unplug the AC power cord when the projector is

not in use. When this projector is connected to an outlet with

the AC power cord, it is in Stand-by mode and consumes a

little electric power.

For the U.K.For Continental Europe

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 66 67

Keine Kommentare

Sanyo PLC-XU75 Bedienungshandbuch Seite 14