Sanyo VMC-8618 Bedienungsanleitung PDF herunterladen (Seite 12)

ADJUST THE OSD MENU ITEM

Displaying characters such as for setting

location on the monitor screen (Refer to

“CHARACTERS TABLE”.)

Note: If there is no signal being input from the input

terminals selected (A, B or Y/C) at the rear of

the monitor, the title cannot be set for those

terminals.

1 Select “9. TITLE ON” and then press the

ENTER button.

2 To display “ABCD” on the CH B monitor as an

example:

A maximum of eight characters can be displayed

on the screen.

Note: The setting screen will disappear after

approximately 13 seconds of no activity.

1. Use the cursor (l) button to select “CH B”.

2. Press the ENTER button, and then use the cursor l

(j) button to select “A”.

3. Press the ENTER button, and then use the cursor l

(j) button to select “B”.

4. Press the ENTER button, and then use the cursor l

(j) button to select “C”.

5. Press the ENTER button, and then use the cursor l

(j) button to select “D”.

6. Press the OSD button.

The cursor will move to the next monitor display.

The settings for the CH A and CH Y/C monitors can

be carried out by the same procedure as described

above.

3 Use the cursor l (j) button to select “TITLE

ON”, and then press the ENTER button.

The text that has been set for that monitor screen

will then be displayed.

OSD

CHARACTERS TABLE

L8MV5/US, L8MW5/US (VMC-8618, 8613 GB) 2001. 2. 23

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Sanyo VMC-8618 Bedienungsanleitung Seite 12