Sanyo PLC-ET30L Bedienungsanleitung PDF herunterladen (Seite 23)

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector.

Confirm the AC plug type with the chart below and proper AC power cord must be used.

If supplied AC power cord does not match your AC outlet, contact your sales dealer.

To power cord

connector on your

projector.

Projector side AC outlet side

Ground

To the AC outlet.

(120 V AC)

For Continental EuropeFor the U.S.A. and Canada

This projector uses nominal input voltages of 100–120 V or

200–240 V AC and it automatically selects the correct input

voltage. It is designed to work with single-phase power

systems having a grounded neutral conductor. To reduce the

risk of electrical shock, do not plug into any other type of

power system.

If you are not sure of the type of power being supplied,

consult your authorized dealer or service station.

Connect the projector with all peripheral equipment before

turning the projector on.

Connecting the AC Power Cord

For the U.K.

To the AC outlet.

(200–240 V AC)

To the AC outlet.

(200–240 V AC)

Installation

Connect the AC power cord (supplied) to the

projector.

✔Note:

 •UnplugtheACpowercordwhentheprojectorisnotinuse.When

theprojectorisconnectedtoanoutletwithACpowercord,itis

instand-bymodeandconsumesalittleelectricpower.

CAUTION

The AC outlet must be near this equipment and must be easily

accessible.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 77 78

Keine Kommentare

Sanyo PLC-ET30L Bedienungsanleitung Seite 23