INSTRUCTION MANUALVCB-3444B/W CCD Camera
CONNECTIONSBasic connection for monitoring or recordingThe peripheral devices (VCR, monitor, lens, etc.) and cables aresold separately.1 Make the vide
SETTINGSCamera setup section• Internal sync (INT)/Line lock (LL) setting• Electronic iris (EI)/Auto iris (AI) setting• Backlight compensation (BLC) se
SETTINGSLens iris adjustmentIf using a DC type auto-iris lens, you will need to set the LEVELvolume when shooting in the conditions described below.L
SETTINGSHigh speed electronic shutter settingNormally, the speed setting switch for the highspeed electronic shutter set to the 0 position.This sets t
TROUBLESHOOTINGBefore taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform c
SPECIFICATIONSScanning system : EIA standard(525 TV lines, 30 frames/sec.)Interlace : 2:1 interlaceImage device : 1/3 inch solid state image device CC
SPECIFICATIONSDimensionsFeatures and specifications are subject to change without priornotice or obligations.ACCESSORIES1 Lens iris plug (4-pin)...
SANYO INDUSTRIAL VIDEOB/W VIDEO CAMERA LIMITED WARRANTYOBLIGATIONSIn order to obtain warranty service, the product must be delivered to and picked up
1AC6P1P2433--L73Q4/US(0501KP-TVS)9823000221605 Plummer Street,Chatsworth, California 91311Printed in TaiwanL73Q4/US GB 2001, 6, 18
Depending on the conditions of use, installation and environment,please be sure to make the appropriate settings and adjustments. Ifyou need help with
Safety GuardTHIS SYMBOL INDICATES THAT THERE AREIMPORTANT OPERATING AND MAINTENANCEINSTRUCTIONS IN THE LITERATURE ACCOMPANYINGTHIS UNIT.WARNING:TO PRE
PRECAUTIONSIn case of problemDo not use the camera if smoke or a strange odour comes from theunit, or if it seems not to function correctly. Disconnec
PARTS NAMES1 Power indicator (POWER)Comes on when the power to the camera is on.2 Camera setup section• Internal sync (INT)/Line lock (LL) setting• El
PARTS NAMESF Flange-back lock screwG Lens mount capThe cap is installed to protect the lens mount section.Remove the lens mount cap before installing
PARTS NAMESConcerning auto-iris lensesDC type auto-iris lensA lens without amplifier circuit that operates only on a DC power source. In general, this
MOUNTING THE LENSPlease use a DC type auto-iris lens (sold separately).Checking the lens mountDo not use a lens if length “L” is more than 9 mm. If no
MOUNTING THE LENSRewiring the lens cable in the lens iris plug1 Prepare the lens cable.Cut the cable at the plug, then remove approx. 8 mm of the cabl
Kommentare zu diesen Handbüchern