Sanyo VCC-6570P Bedienungsanleitung

INSTRUCTION MANUALBEDIENUNGSANLEITUNGMANUEL D’INSTRUCTIONSVCC-6570PCOLOUR CCD cameraCCD-FarbkameraCaméra CCD COULEURCCDAbout this manualBefore install

CONNECTIONSBasic connection for monitoring or recordingThe peripheral devices (VCR, monitor, lens, etc.) and cables aresold separately.1 Make the vide

CONNECTIONSConnections to the camera Y/C OUT connectorThe peripheral devices (VCR, monitor, lens, etc.) and cables aresold separately.1 Using a coaxia

SETTINGSThe illustration shows the factory default settings for the switches in the camera setup section.The camera settings are described on the assu

SETTINGSHigh speed electronic shutter settingNormally, the speed setting switches for the high speed electronicshutter are all set to the down (OFF) p

SETTINGSBacklight compensation settingThis camera has two different backlightcompensation functions: Normally backlightcompensation switch 6 (MULT) an

SETTINGSWhite balance adjustmentNormally the switch 8 (WB) is set to the down (ATW: auto whitebalance) position and the white balance is adjusted auto

SETTINGSExternal sync adjustment (VBS)1 Connect the VBS signal output for the other camera to the VBSIN connector at the rear of this camera.2 If the

TROUBLESHOOTINGBefore taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform c

SPECIFICATIONSCamera:Scanning system: PAL standard(625 TV lines, 25 frames/sec.)Interlace: PLL 2:1 interlaceImage device: 1/3 inch solid state image d

SPECIFICATIONSDimensionsFeatures and specifications are subject to change without prior notice or obligations.1222111.31361281/4”–20 UNC675428L53T5/XE

Depending on the conditions of use, installation and environment,please be sure to make the appropriate settings and adjustments. If youneed help with

1AC6P1P2453--L53T5/XE (0801KPS-DSP)Sanyo Electric Co, Ltd.Printed in JapanL53T5/XE GB 2001, 7, 26

PRECAUTIONSIn case of problemDo not use the camera if smoke or a strange odour comes from theunit, or if it seems not to function correctly. Disconnec

PARTS NAMES1 Power indicator (POWER)Comes on when the power to the camera is on.2 Video output connector (VIDEO OUT: BNC type)Connect this connector t

PARTS NAMES7 Lens mount capThe cap is installed to protect the lens mount section.Remove the lens mount cap before installing a lens (sold separately)

PARTS NAMESG Lens iris output connector (LENS)This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.H

CONCERNING AUTO-IRIS LENSESDC type auto-iris lensA lens without amplifier circuit that operates only on a DC power source. In general, this type of le

MOUNTING THE LENSPlease use a DC type auto-iris lens (sold separately).Check the lens mountDo not use a lens if the length “L” is more than 5 mm. That

MOUNTING THE LENSRewiring the lens cable in the lens iris plug1 Prepare the lens cable.Cut the cable at the plug, then remove approx. 8 mm of the cabl