Sanyo VCC-6594P Bedienungsanleitung

INSTRUCTION MANUALBEDIENUNGSANLEITUNGMANUEL D’INSTRUCTIONSVCC-6592PVCC-6594PCOLOUR CCD cameraCCD-FarbkameraCaméra CCD COULEURCCDAbout this manual• Bef

MOUNTING THE LENSRewiring the lens cable in the lens iris plug1 Prepare the lens cable.Cut the cable at the plug, then remove approx. 8 mm of the cabl

CONNECTIONS (VCC-6592P only)Basic connection for monitoring or recordingThe peripheral devices (VCR, monitor, lens, etc.) and cables aresold separatel

CONNECTIONS (VCC-6592P only)Connections to the camera Y/C OUT connectorThe peripheral devices (VCR, monitor, lens, etc.) and cables aresold separately

CONNECTIONS (VCC-6594P only)Basic connection for monitoring or recordingThe peripheral devices (VCR, monitor, lens, etc.), AC adaptorand cables are so

SETTINGS (VCC-6592P only)The illustration shows the factory default settings for the switches in the camera setup section.The camera settings are desc

SETTINGS (VCC-6594P only)The illustration shows the factory default settings for the switches in the camera setup section.The camera settings are desc

SETTINGSElectronic shutter settings and electronic irissettingsWhen all of these switches are down, electronic shutter (1/50 sec orauto iris setting)

SETTINGSBacklight compensation settingThis camera has two different backlightcompensation functions: Normally backlightcompensation switch 6 (MULT) an

SETTINGSWhite balance adjustmentNormally the switch 8 (WB) is set to the down (ATW: auto whitebalance) position and the white balance is adjusted auto

SETTINGSLens iris adjustmentIf using a DC type auto-iris lens, you will need to set the LEVEL(VR301) volume when shooting in the conditions described

1AC6P1P2424--L53H2, H4/XE (0901KPS-DSP)Sanyo Electric Co, Ltd.Printed in JapanL53H2, H4/XE GB 2001, 9, 18

TROUBLESHOOTINGBefore taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform c

SPECIFICATIONSCamera:Scanning system: PAL standard(625 TV lines, 25 frames/sec.)Interlace: PLL 2:1 interlaceImage device: 1/3 inch solid state image d

SPECIFICATIONSDimensionsFeatures and specifications are subject to change without prior notice or obligations.12.622.4110.51091001/4”–20 UNC5645285645

Depending on the conditions of use, installation and environment,please be sure to make the appropriate settings and adjustments. If youneed help with

PRECAUTIONSIn case of problemDo not use the camera if smoke or a strange odour comes from theunit, or if it seems not to function correctly. Disconnec

PARTS NAMES1 Video output connector (VIDEO OUT: BNC type)Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector.2 Power

PARTS NAMES7 Lens mount capThe cap is installed to protect the lens mount section.Remove the lens mount cap before installing a lens (sold separately)

PARTS NAMESG Lens iris output connector (LENS)This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.H

CONCERNING AUTO-IRIS LENSESDC type auto-iris lensA lens without amplifier circuit that operates only on a DC power source. In general, this type of le

MOUNTING THE LENSPlease use a DC type auto-iris lens (sold separately).Check the lens mountDo not use a lens if the length “L” is more than 5 mm. That