Sanyo CH1872 Bedienungsanleitung Seite 107
- Seite / 111
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
21
How to Test Run the Air Conditioner
After turning on power to the air conditioner, use the remote
controller and follow the steps below to conduct the test run.
(1) Set the remote controller in Test Run mode.
(Fig. 59a)
a) Press and hold the ION button.
b) Then press and hold the 1HR TIMER button.
c) At the same time, press the ACL (reset) button once.
Use a pointed object such as the tip of a pen to press
the ACL button.
• After a few seconds, “ ” appears and “oP-1” blinks in
the remote controller display area.
(Fig. 59b)
d) Release the 1HR TIMER button.
e) Release the ION button.
(2) Start Cooling mode test run by pressing the ON/OFF
operation button of the remote controller. (Fig. 59a)
• This starts the fan producing uncooled forced air with
the 4 indicator lamps (OPERATION lamp, TIMER
lamp, QUIET lamp, and ION lamp) on the main unit
blinking. (Fig. 59c)
• After 3 minutes, the system shifts into cooling opera-
tion, and cool air will start to be felt. Cool mode test
run is unaffected by the room temperature.
(3) Press the ON/OFF operation button of the remote con-
troller again to stop the test run. (Fig. 59a)
(4) Finally press the ACL (reset) button of the remote con-
troller to release it from Test Run mode to return to nor-
mal mode. (Fig. 59a)
• “ ” and “oP-1” will disappear from the remote con-
troller display area.
Troubleshooting:
In the event that the green “Operation Light” is blinking upon
powering up the system, an error condition exists. In this
case, refer to the self-diagnostics procedure on the
inside of the front cover.
After the test run is completed, be sure to press the
ACL (reset) button to return to normal mode. The
air conditioner will not operate correctly if this is not
done.
IMPORTANT
NOTE
Fig. 59a
Fig. 59b
Fig. 59c
A
1HR.
TIMER
ON/OFF
operation
ACL
(Reset)
ION
button
button
button
button
OPERATION lamp
TIMER lamp
QUIET lamp
ION lamp
07-153 CH1872-2472 6/12/07 3:15 PM Page 21
- KHS1872 + CH1872 1
- KHS2472 + CH2472 1
- Important! 2
- Please Read Before Starting 2
- Table of Contents 3
- 1. OPERATING RANGE 5
- 2. SPECIFICATIONS 6
- Indoor Unit KHS1872 7
- Outdoor Unit CH1872 7
- < 208V > 7
- < 230V > 8
- 2-2-1. Indoor Unit 10
- Indoor Unit KHS2472 11
- 2-2-2. Outdoor Unit 12
- Outdoor Unit CH2472 13
- 3. DIMENSIONAL DATA 15
- Outdoor Unit CH1872 16
- Outdoor Unit CH2472 17
- 4. REFRIGERANT FLOW DIAGRAM 18
- 5. PERFORMANCE DATA 19
- Indoor air temp.73 20
- Hi FanLo fan 21
- Indoor air temp.73°F ( 22
- 5-2. Cooling Capacity 23
- Indoor Unit : KHS2472 24
- Outdoor Unit : CH2472 24
- < Cooling Capacity > 24
- Indoor Unit : KHS1872 25
- Outdoor Unit : CH1872 25
- 5-4. Heating Capacity 27
- °F (21.1°C) 29
- Indoor Unit KHS1872 29
- Indoor Unit KHS2472 30
- 6. ELECTRICAL DATA 31
- Indoor Unit 32
- Outdoor Unit 32
- Indoor Unit KHS1872 KHS2472 33
- 7. MAINTENANCE 36
- Pull the cover upward 37
- 8. FUNCTIONS 38
- HIGH POWER 39
- NIGHT SETBACK 39
- Lamp colors 39
- Timer backup 39
- 8-2. Protective Functions 40
- Defrost detection and release 41
- 9. TROUBLESHOOTING 42
- (1) Checking the indoor unit 45
- (2) Checking the outdoor unit 45
- (3) (2) (1) 46
- Defect in the outdoor unit 47
- P. C. board 47
- Defect or connection error 47
- (3-2) Condition: E12 48
- 9-4-1. Indoor Fan Motor 49
- 9-4-2. Outdoor Fan Motor 50
- (1) Noise malfunction 51
- Resistance 52
- PCB Ass'y 53
- 11. REFRIGERANT R410A: 54
- INSTRUCTION MANUAL 61
- APPENDIX A 61
- Features 62
- Contents 63
- Product Information 63
- Alert Symbols 63
- Installation Location 64
- Electrical Requirements 64
- Safety Instructions 64
- Names of Parts 65
- OI-801-6-EG 66
- Remote Control Unit (Display) 67
- Remote Control Unit 68
- OI-801-9EG 69
- Using the Remote Control Unit 70
- OI-801-11EG 71
- 1. Automatic Operation 72
- 2. Manual Operation 73
- 3. Adjusting the Fan Speed 74
- 4. Fan Only 74
- 5. Night Setback Mode 75
- 76
- 6. QUIET Mode 76
- 7. HIGH POWER Mode 76
- 8. ION Mode 76
- Special Remarks 77
- Setting the Timer 78
- 3. How to set the ON time 79
- 4. How to set DAILY ON/OFF 79
- REPEAT timer 79
- Using the 1-Hour OFF Timer 80
- Tips for Energy Saving 80
- OI-801-21EG 81
- Operation without the Remote 82
- Control Unit 82
- Care and Cleaning 82
- Care and Cleaning (continued) 83
- Troubleshooting 85
- Operating Range 85
- INSTALLATION INSTRUCTIONS 86
- APPENDIX B 86
- INSTALLATION INSTRUCTIONS 87
- SPECIAL PRECAUTIONS 88
- 1. General 89
- About 4" (10 cm) 91
- About 1'4" (40 cm) 91
- About 6" (15 cm) 91
- Rear panel 92
- 3/16" 93
- (4.8 mm) dia. hole 93
- Rawl plug 93
- Power supply 96
- Single phase 230/208V 60HZ 96
- Terminal Terminal 96
- Strip 15/16" (25 mm) 98
- Strip 3/8" (10 mm) 98
- Padding material 99
- 5. Refrigerant Tubing 103
- Insulated tubes 104
- Apply putty here 104
- 6. Air Purging 105
- QUIET lamp 107
- ION lamp 107
- OPERATION lamp 107
- TIMER lamp 107
- Pump Down 108
- 8. Address Switch 110
Verwandte Produkte und Handbücher für Mobile Klimaanlagen Sanyo CH1872
(24 Seiten)
(50 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.637 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern