Sanyo CH1872 Bedienungsanleitung PDF herunterladen (Seite 92)

Set screw only for transportation

Fig. 6

Rear panel

marks

Fig. 7

Left

tubing

Right tubing

Downward tubing

Right-rear

tubing

(recommended)

Left-rear

tubing

Fig. 8

3. How to Install the Indoor Unit

3-1. Remove the Rear Panel from the Unit

(1) Remove and discard the set screw on the rear

panel. (Fig. 6)

(2) Press the 2 LL marks on the frame cover and disen-

gage the stationary tabs from the frame. (Fig. 7)

(3) Remove the rear panel.

Tubing can be extended in 5 directions as shown in Fig.

8. Select the direction you need providing the shortest

run to the outside unit.

G When left tubing is to be done, switch the drain hose

and drain cap. (For details, refer to “Switching drain

hose and drain cap” on page 14.)

3-2. Make a Hole

(1) Place the rear panel from the indoor unit on the wall

at the location selected. Make sure the panel is hori-

zontal, using a carpenter’s level or tape measure to

measure down from the ceiling. Wait until after cut-

ting the hole before attaching the rear panel to the

wall.

(2) Determine which side of the unit you should make

the hole for tubing and wiring. (Fig. 9)

In the case of left-rear tubing, use the measurement

points 2-3/8" (60 mm) from the edge of the rear panel for

precise placement of the hose outlet. (Fig. 9)

(3) Before making the hole, check carefully that no

studs or pipes are directly run behind the spot to be

cut.

The above precautions are also applicable if tubing

goes through the wall in any other location.

NOTE

2-3/8" (60 mm)

Fig. 9

CAUTION

Also avoid areas where elec-

trical wiring or conduits are

located.

07-153 CH1872-2472 6/12/07 3:15 PM Page 6

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 110 111

Kommentare zu diesen Handbüchern

Keine Kommentare

Sanyo CH1872 Bedienungsanleitung Seite 92

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mobile Klimaanlagen Sanyo CH1872