Sanyo PLC-ZM5000L Bedienungshandbuch Seite 72
- Seite / 92
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
The WARNING indicators show the state of the function which protects the projector. Check the state of the
WARNING indicators and the POWER indicator to take proper maintenance.
The projector is shut down and the WARNING TEMP.
indicator is blinking red.
When the temperature inside the projector reaches a
certain level, the projector will be automatically shut down
to protect the inside of the projector. The POWER indicator
is blinking while the projector is being cooled down. When
the projector has cooled down enough (to its normal
operating temperature), it can be turned on again by
pressing the ON/STAND-BY button.
Note:
TheWARNINGTEMP.indicatorcontinuestoblink
evenafterthetemperatureinsidetheprojectorreturns
tonormal.Whentheprojectoristurnedonagain,the
WARNINGTEMP.indicatorstopsblinking.
Then check the matters below:
– Did you provide appropriate space for the projector to be
ventilated? Check the installing condition to see if the air
vents of the projector are not blocked.
– Has the projector been installed near an Air-Conditioning/
Heating Duct or Vent? Move the installation of the
projector away from the duct or vent.
– Is the filter clean? Replace the filter with a new one.
The projector is shut down and the LAMP indicator is
lighting and other indicators are blinking.
When the projector detects an abnormal condition, it
will be automatically shut down to protect the inside
of the projector and the LAMP indicator lights on and
other indicators blink. In this case, unplug the AC
power cord and plug it, and then turn on the projector
once again to verify operation. If the projector cannot
be turned on and these indicators are still lighting and
blinking, unplug the AC power cord and contact the
service center.
CAUTION
DO NOT LEAVE THE PROJECTOR WITH THE
AC POWER CORD CONNECTED UNDER AN
ABNORMAL CONDITION. IT MAY RESULT IN
FIRE OR ELECTRIC SHOCK.
Top Panel
LAMP indicator lights on
and other indicators blink.
Top Panel
WARNING TEMP.
blinking red
Maintenance and Care
Warning Indicators
72
- Owner’s Manual 1
- Features and Design 2
- Table of Contents 3
- To The Owner 4
- Safety Instructions 5
- IMPORTANT! 6
- Filter Maintenance!! 6
- Moving the Projector 8
- Compliance 9
- Part Names and Functions 10
- Rear Terminal 11
- Side Control 12
- Indicators (on the top panel) 12
- Remote Control 13
- Remote Control Code 16
- Adjustable Feet 16
- Installation 17
- Lens Installation 18
- Analog Out Signal Table 20
- Connecting for Audio Signal 21
- Basic Operation 22
- Enter a PIN code 23
- Input 1 23
- RGB(PC analog) 23
- Direct OFF Function 24
- Main Menu 26
- Sound Adjustment 28
- Information Menu 29
- User 1 of PIP (example) 30
- User 2 of PIP (example) 30
- Pointer Function 32
- Wireless Mouse Operation 32
- Input Selection 33
- INPUT button* 33
- Direct Operation 33
- Video Input Source Selection 35
- PC System Menu 36
- PC adjust Menu 37
- Mode free 39
- Image select Menu 40
- Image adjust Menu 41
- SCREEN MENU 42
- Custom adj 43
- Keystone 44
- Ceiling 44
- Video Jack or S-video Jack 45
- Y, Pb/Cb, Pr/Cr Jacks 45
- Video Input 48
- Logo select 52
- Logo PIN code lock 53
- When using side control 54
- When using remote control 54
- Picture in Picture 55
- Position Menu 55
- HDMI setup 56
- To store the adjusted data 56
- Lamp control 57
- Lamp life control 57
- Simple mode buttons 58
- Filter control 58
- No signal 59
- Key lock 61
- PIN code lock 61
- Protection 63
- Management 63
- Release key 63
- Closed caption 64
- Filter counter 65
- Maintenance and Care 66
- Scroll counter Reset? 68
- Lamp Replacement 69
- Cleaning the Projection Lens 71
- Warning Indicators 72
- Problem: Solutions 73
- Appendix 74
- Menu Tree 76
- Indicators 79
- Projector Condition 79
- Technical Specifications 84
- Optional Parts 85
- PJ Link Notice 85
- Lens Replacement 85
- Configurations of Terminals 86
- PIN Code Number Memo 87
- Dimensions 88
- Serial Control Interface 89
- List of Picture in Picture 89
Verwandte Produkte und Handbücher für Datenprojektoren Sanyo PLC-ZM5000L
(51 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 3.011 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern